0

  Home Page | About Us | Product | Contact Us  
 
0 
 
 
  Product Detail As Below Link  
   
  0

Lauterbach Emulator and Debugger solutions offering solutions for ARM,XScale, PowerPC, XC16x and a huge range of other microcontroller cores. Debuggers also supports debugging standards such as JTAG/OCDS/BDM interfaces with RTOS awareness…find out more

 
 
  0

 

 

Trace32 Powerview the flexible and fast user interface.

 

 

 

0  

Trace32 ICD debugger based on the on chip debug interface or a ROM monitor solution.

 

 

  0

Trace 32 Product connect to this to control the core, access the data being processed by the core and provide developers with debugging over the embedded device.

 

 
 
  0

 

Trace32 ICE the sophisticated high end In-circuit emulator for CISC processor.

 

.

 

0  

 

Trace32 Linux Debugging of single core systems and SMP systems.

 

.

 

  0

Trace32 uTrace for Cortex-M support stardard JTag, Serial Wire Debug and cJtag (IEEE 1149.7) with 256 MByte trace memory. Voltage rance 0.3V to 3.3V (5V tolerant inputs).

 

 
 
  0

 

Trace32 Debug & Trace for Arm support simultaneous debug and trace of homegeneous and heterogeneous multicore and multiprocessor systems with one debug tool.

 

 

0  

 

PowerProbe-Logic & Protocol Analyzer timing up to 400 MHz, State Analyzer up to 100 MHz.

 

.

  0

PowerIntegrator-Logic & Bus Analyzer come with 204 Input Channels and 4 Clock Inputs. Timing Analyzer with 500 MHZ and State Analyzer up to 200 MHz DDR.

 

 
  0  

Asset is the official recommended emulator solution by Intel supporting their line of Generation 6 and Generation 7 processors which provides ITP (JTAG) debugging solutions. Also, the latest JTAG debugger supports ARM 7,9,11 TI OMAP, and XScale processors in the recent release .... find out more

 
 
 

Asset LX-1000e Trace Port Analyzer with Deep Trace and 2GBytes of trace memory

 

.

0

ECM-XDP3e JTAG Emulator for targets with XDP debug ports.

 

.

0

 
  0

 

Asset LC-500Se ARM JTAG Debugger for targets with ARM cores with up to 20MHz device frequency. Download speed up to 200KBytes/sec and 10/100/GE Ethernet USB 2.0.

 

 

  0

Closed Chassis Controller debug software problems & Intel developed the DCI specification to provide solutions in this space (Direct Connection Interface)

 

 
  0 Asset JTAG Adapters & Interposers fit on the end of personality modules or flex cables that run from emulator to a device under test (target).  
  0

iSystem In-circuit Emulator range for C166/167/C51/HCxx/68K controllers.Offers source level debugging support for most compilers. Wide range of the support for different derivatives of controllers and processors….find out more

 
 
  0   • iSystem Product Overview
 
iSystem testIDEA offers test automation capabilities by executing test cases and test vectors on a real hardware without code instrumentation
 
iSystem I/O Module iC5000 add-On for real word debug and test scenarios
 
iSystem Cortex Debugger USB and Wireless debugger for ARM/Cortex
 
   
 
  0  

 
i-System iC5000

The iC5000 supports almost all 32-microcontrollers. By adding the IOM2 accessory, the iC5000 can be expanded to monitor digital and analog signals on your embedded hardware.

 

  0  

iSystem iC5700
Steady increase in multi-core and multi-processor, system-on-chip (SoC) processing platforms, with the pace of integration being especially pronounced in the automotive industry.

 

 
   
i-System iC6000
Designed specifically to support the high-speed serial interfaces featured on advanced 32-bit microcontrollers.
  0  
i-System Analog Digital CAN2/LIN2

The CAN/CAN-FD and LIN bus network data can be captured and displayed in parallel to the microcontroller code execution domain.
  0  
                 
  0   0   0   0  
  Infineon MPC5x/SPC5x
MPC5x/SPC5x Aurora Active Probe enables the debugging, tracing and testing of NXP Qorivva (MPC5xxx) and ST SPC5 microcontroller families. Besides the JTAG debug interface it supports Aurora trace interface operating at its maximum frequency.
  Infineon DAP/DAPE
Infineon DAP/DAPE  Active Probe enables the debugging, tracing and testing  of Infineon’s AURIX™ microcontroller  family.  It  supports  the  DAP debug  interface  operating  at  their maximum frequency. On 2nd generation AURIX devices it optionally also supports the DAPE interface.
  Infineon AGBT
The iSYSTEM Active Probe has been developed to connect to the Aurora GigaBit Trace (AGBT) interface along the DAP debug interface at its maximum frequency.  Both, Infineon AurixTM TC2xx and TC3xx (2nd generation) microcontrollers are supported.
  Infineon ARM HSSTP
The Cortex™ families of processors continue to appear in increasingly complex system-on-chip (SoC) devices. In order to access the volume of trace information created by such products, ARM® has developed a new intellectual property (IP) block named High Speed Serial Trace Port (HSSTP).
 
 



 

 

 

 


 

 

 

 
 
  Item By Categories  
 
0 0 0 0 0
Debugger Compiler Analyzer Tester Programmer
  FEATURED BRAND  
0 0 0 0
0 0 0 0
0 0 0 0
0 0 0
0      
     
     
  Coming Soon PRODUCT & BRAND......  
  .0 0    
         
     
 
www.flashtech.com.my
 
0 HQ : Flash Technologies Pivate Limited | No.61, Kaki Bukit Avenue 1#04-15 Shun Li Industrial Park Singapore 417943 | Tel : (65) 6749 6168 | Fax : (65) 6749 6138 | Email : sales_sg@flashtech.com.sg | Website : www.flashtech.com.sg
Branch (Malaysia) : Flash Embedded Tools Sdn Bhd | THE C.E.O 31-11-13, Lebuh Nipah 5, Bayan Lepas, 11950 Pulau Pinang, Malaysia | Tel : (604) 606 3699 | Fax : None | Email : sales@flashtech.com.my| Website : www.flashtech.com.my
 

Copyright © 2015-2024 Flash Embedded Tools Sdn Bhd | All right reserved | Term of services | Privacy Policy